|
Techno Pex Pipes for ground heating nets |
|||
| The ground heating system depends on posing hot of low temperature (40o - 50o) Celsius, within a net of pipes distributed upon the ground insulator all over the place by many circulators, thereby each circulator consist of a single pipe (without joints), this pipe passes through a union of the backward line. | |||
| The geometric study defines the quantity of width between the pipes. since there are differences in temperature of the heated places, then pipes must be densities in the cold places so that the surfaces temperatures become equal, no way must the ground get a temperature higher than (28o - 30o) | |||
| Characteristics | |||
| ►A better exploitation of the rooms areas, with full control of the furniture due to deletion of radiators installment. | |||
| ► The ground heating system distributes temperature equally, and prevents cold or hot air streams as of the traditional heating. | |||
| ►No black blast as existed usually over the radiators as a result of dust - atom burning. | |||
| ►Ground heating is the idea solution for heating big areas of big hights as in mosques churches galleries , closed, swimming, pools, and the eves problems of heating in such places is the thermal assemblage in the high areas. | |||
| ►The correct result of the ground heating system start from the correct geometrical designation, which Techno Therm company present FREE. | |||
| ►The cost of using Technopex pipe in ground heating system is equal to that of heating by radiators. | |||
| ►The radiation of heat, from down - up ward over all the surface of the radiation ground, makes the heating of high performance, compared with the other fore, gives a felling of comfort because it's the closest to an ideal distribution of heat in the human body . | |||
|
|
|||
|
|||
| Installation | |||
| ► We put the insulator board (strawboards) on the ground of the desired heating place there to yet the wanted insulation, this insulation is characterized of high density and pressure with 3 cm. | |||
|
|
|||
| ► Put the reflectors sheet before putting the pipes thus reducing the thermal loose rate and getting higher heating as well. | |||
| ► Distribute Technopex pipes upon the reflector sheet according to a geometrical lineation that was put by experts of the company in the studies - department. | |||
| ► Connect the pipes heads to the lopper unions existed in the cabinet which was first fixed in a way that the pipe goes out from the outlet - union, then goes back into an inlet-union. | |||
| ► Put the pipes under pressure 10 bar. | |||
|
► Pour the cement layer ( together with special plastic material supplied by the company) and leave expansion partings around this cement body. |
|||
 |